How to Choose the Right Mitre Saw

A miter saw is the quickest way to come to be an obvious genius at precisely slicing lumber and trim. Sometimes known as a hacksaw, these saws make precise angled move cuts. They are in particular useful for repeating the equal cut at an angle, quickly and appropriately. Although all the fashions are similar, there are three foremost types to pick from.

Simple miter saws have a blade and motor assembly that rotates down into the wood to make every reduction. The wooden rests on a table that swivels one way or every other for angled cuts. A 10 ″ blade saw could make a ninety ° pass cut via a 2 × 6; a 12 ″ can take care of a 2 × 8. These simple saws were as soon as commonplace, however, today fewer manufacturers produce them.

Get one if:

• Money is tight
• You want a light-weight saw that you may deliver effortlessly.
• It simplest makes vertical cuts (no compound angles).
• You normally reduce 2 x 6 or much less.

Compound miter saws, like easy miter saws, rotate downward to finish a cut, but the blade and motor can also be tilted far from vertical at a variety of angles. This capacity permits angle control in two guidelines, so you can reduce compound angles. These saws cut the same width of timber as simple miter saws.

Get one if:

• A little greater weight and a better rate are fine.
• You are operating on trim, ceiling frames, or different tasks wherein cutting wooden at two angles is vital.

Sliding compound miter saws region the blade and motor assembly on rails or an articulated arm, so it could circulate back and forth, in addition, to tilt facet to aspect and swing all the way down to make cuts. The sliding motion lets in a 90º cross reduce of wooden as much as a width of 12 ″, making this miter saw the maximum versatile. But there's an exchange-off for this variety of motion: extra components that move can suggest cuts that are less precise.

Get one if:

• You are frequently slicing wide forums.
• Weight and price don't trouble.
• It is pleasant with slightly rougher and less particular cuts than different miter saws provide.

How to check your miter saw

The markings on the miter saw display 45 °, 90 °, and different angles. Don't continually agree with them. Try making a 90 ° vertical cut in a 1 × 3 or 1 × 4 directly. Flip the cutout over, then convey the reduced ends collectively, with the rims of each piece snug towards the fence. If there is an opening wherein the ends meet, that perspective is twice the error of the saw. Different saws regulate differently (check your guide). Once you set a ninety ° cut, all different aspect to side angles could be correct. On compound saws, repeat the test to make certain the blade is precisely vertical. If the 45 ° corners of your trim still do not match properly, blame the old door body or window body and make your cut a touch square to catch up on the usual log cabin awkwardness.