How to Use a Coping Saw on Cove Molding

Cove molding is aptly named for its concave profile that softens the appearance of the intersection in which a ceiling meets a wall. Crown molding is usually attached on the interior corners with miter cuts at the ends of each piece. But many inexperienced DIY fanatics discover it tough to make the concave moldings fit flawlessly with adjoining miter cuts. The solution is to apply a jigsaw to suit one cease of one part towards the face of the adjoining component. This saves time and improves the uniformity of the inside corners.

Start by measuring the lengthy and brief contrary partitions in a room. Work from ladders and feature an assistant assist you measure every wall on pinnacle from one cease to the other. Check the dimension for long partitions and degree portions of pine or hardwood trim lengthwise. Mark the points of the cuts with a carpenter's pencil.

Make rectangular cuts at the marks on every piece with a miter noticed or a miter field and hand noticed. Install the portions on the pinnacle of the longest walls with end nails and an end hammer. The length of the nails relies upon the scale of the molding. Typically, 4-cent end nails are used with a 3/four-inch cleat and 6-cent nails with a bigger cleat. Drive pairs of nails into the top and backside faces of the trim at 24-inch periods from end to give up.

Check your measurements for shorter partitions. Score a custom cup molding piece and cut opposing 45 diploma miter cuts at every end. The open faces of 45-degree cuts face each different, just like the inside miter corners in other forms of trim.

Place the shorter piece on a workbench with one-cease mitered extending just past one edge of the table. Use a pencil to highlight the cut line wherein the face of the miter reduces meets the completed face of the trim. Stabilize the part with one hand and reduce the line with a jigsaw to cast off the angled part of the miter reduce. Repeat this and face the miter cut on the alternative end of the piece.

Ask the assistant that will help you function the piece on the pinnacle of a shorter wall. Fit the ends of the piece with the caps in opposition to the corresponding ends of the longer portions at every nook. Nail the shorter piece with pairs of finish nails at 12-inch periods. Repeat the technique to cut and face the closing piece for the opposite, shorter wall. Install the piece among the other ends of the corresponding longer portions.