How to Cut Without a Miter Box

Miter saws are most usually used for trim and for a cause: trim is usually installed with miter (angled) cuts in the corners. A miter saw is the only manner to get precisely that right attitude. However, in case you want to put in trim without a miter box, there is a way to do it using the best rectangular cuts, which you may make with a popular round saw. When the use of nook blocks to shape the corners, keep away from mitering altogether.

Step 1

Pre-drill 4 nail holes together with your pilot bit into every of the nook block trim portions. Place two holes, pinnacle and bottom, along with the blocks in each course. Offset the hole positions sufficient in order that they do not move each other.

Step 2

Stand a block in a nook of the room. Place a small level subsequent to it and follow it flawlessly, up and down. Hammer slicing nails through the 2 holes on each uncovered aspect of the block inside the wall at the back of it to steady it. Drill down the nail heads with a set of nails. Follow the equal procedure to put in nook blocks in each nook of the room.

Step 3

Measure among of the corner blocks, from the internal aspect of every, with a tape measure. Mark the size on a longer side piece with a pencil. Do not degree from the give up as it can not be square. Make a mark some inches from one end of the molding, then start measuring the wall from there to make the second one mark.

Step 4

Mark directly traces along with the trim at both marks. Place a take a look at rectangular along the brink of the trim to make certain the traces are absolutely rectangular.

Step 5

Cut the trim with a circular saw. Cut slowly and in a direct line alongside both lines.

Step 6

Place the reduced trim among the two corner blocks in order that the rectangular reduced ends of the trim contact the perimeters of the blocks. Drill pilot holes every 12 to sixteen inches alongside the top and bottom edges of the trim.

Step 7

Hammer into end nails. Sink the heads under the floor with a fixed of nails. Repeat for each section of the wall among all corner blocks.